With over 20 years of experience, we own 6 factories in the Shunde District, Guangdong Province, producing mainly the following magnetic materials: Ferrite Magnets, Rubber Magnets, Bonded / Sintered Neodymium (NdFeB), Rare Earth Magnet, AlNiCo, Samarium (SmCo), Bonded Magnet Powder and Rubber Iron Sheet.

If you are deciding which kind of magnet most suitable for your products, you can check out the following brief characteristics and detail physical and magnetic properties data sheet in linked pages, or contact us directly! We welcome your inquiry anytime!

1) Sintered Ferrite Magnet

- Produced by powder metallurgical method
- Relatively Brittle & Hard
- Good Resistance to demagnetization
- Excellent Corrosion Resistance
- Good Temperature Stability
- Raw material is readily available & low in cost
- Most widely used Permanent Magnets

>>> Detail Properties

2) Rubber Magnet

- Made of bonded ferrite magnet powder, compound rubber & other materials
- By extruding, rolling or injecting, the combination can be made into soft, plastic and flexible magnets with different shapes, such as strip, coil, sheet, and other complicated shapes.
- Widely used in micromotor, fridge, disinfecting cupboard, toys, promotion advertising and etc.
- Good Demagnetization resistance & Reasonable resistance to chemical agents. Material is readily available & low in cost.

3) Iron Rubber Sheet

- Made of iron powder and rubber
- Not magnetised itself, but can be attracted very good by magnet. Just like Iron sheet.
- Soft and harmless to children, extremely good for developing children's products

>>> Detail Properties

4) Neodymium (NdFeB)

- A kind of Rare Earth Magnets, made by bonded, injected, & sintered method
- Bonded NdFeB, High Precision, Excellent Magnetic Properties, Stable Working Temperature & Good Corrosion-Resistance
- Injected NdFeB, High Precision, High Acceptable rate of products & Easily form the Anisotropic super-thin ring or block magnets
- Sintered NdFeB, Very Brittle & Hard, High Resistance to Demagnetization, Excellent cost to performance Ratio, Reasonable Temperature Stability, & Not Suitable for applications which exposed in high temperature conditions

>>> Detail Properties

5) AlNiCo

- Made by Casting or Powder metallurgical methods
- Very hard & brittle
- Poor Demagnetization Resistance
- Produce good flux density at an reasonable cost
- Outstanding Thermal Stability

>>> Detail Properties

6) Samarium (SmCo)

- Made by powder metallurgical method
- Extremely Hard & Brittle
- High demagnetization resistance
- Limited raw material supply, high in cost
- Outstanding thermal stability
- Excellent Anti-Corrosion Properties

>>> Detail Properties

7) Bonded Magnet Powder

- Raw Material of rubber and ferrite magnet
- Suitable for rolled and extrusion production style
- 8 different grades of Isotropic, Semi-Aniso and Anisotropic

>>> Detail Properties